Ver18-SP0.1 SheetWorks for Unfold (Embedded) 64bit Patch Version Installation Procedure ***** Improvements ***** [Batch Unfolding Process, Batch Tube/Structural Steel Unfolding Process, Batch Conductor Process, and Batch Steel Analyze Process] - afpc7864/afpc7865 Fixed the button behavior issue in dialog boxes that caused an application failure. [Batch Steel Analyze Process] - afpc7752 Fixed the issue that failed to insert notch dimensions automatically if notches are created by [Steel Setback] of SheetWorks. * Angle steel and Channel steel are supported only * Dimensions cannot be inserted if tabs and/or notches are applied on a setback portion. ***** Installation Precautions **** (1) Close SheetWorks before starting installation. (2) This patch file is effective for the target software and version only. Confirm that the target software and version is installed. (3) The target software is SheetWorks for Unfold (Embedded). (4) This patch is NOT effective for SheetWorks for Unfold (Addin), SheetWorks for Design, and SheetWorks for Tube. (5) The target software version is [Ver18-SP0.0 (18.0.0.1)]. (6) The version number will be [18.0.1.1] after installation. ****** Installation Procedure ************ (1) Close SheetWorks in the installation destination machine. (2) Run [V18SP0.1Patch_Unfold_Embedded_64.exe]. (3) Proceed installation according to the dialog. @* If the [Program Compatibility Assistant] window appears while installing, select either [This program installed correctly] or [Cancel].