Ver16-SP1.2 SheetWorks for Tube 32bit Patch Version Installation Procedure
					Amada CO., LTD. 
   ***** Improvements *****


	[Define Attribute (Tube)]
	- afpb9428
	  Fixed an issue of Paint a Base Front Face process that caused an application failure.

	[Analyze Shapes]
	- Fixed an issue of Analyze Circle Holes that caused an application failure that occurred while running Analyze again after clearing results.

	[Unfold Structural Steel]
	- afpc0128
	  Fixed an issue of unfolding direction calculation process that failed to lay out a flat part correctly.

	[Parameters]
	- It is now available to specify a temporary folder directly under a drive (both local/network).


    ***** Installation Precautions ****

  (1) Close SheetWorks before starting installation.

  (2) This patch file is effective for the target software and version only.
      Confirm that the target software and version is installed.

  (3) The target software is SheetWorks for Tube.

  (4) This patch is NOT effective for SheetWorks for Design and SheetWorks for Unfold.

  (5) The target software version is from [Ver16-SP1.0 (16.1.0.1)] to [Ver16-SP1.1 (16.1.1.1)].

  (6) The version number will be [16.1.2.1] after installation.


    ****** Installation Procedure ************

  (1) Close SheetWorks in the installation destination machine.

  (2) Run [V16SP1.2Patch_Tube_32.exe].

  (3) Proceed installation according to the dialog.

�@* If the [Program Compatibility Assistant] window appears while installing, select either 
[This program installed correctly] or [Cancel].