Ver17-SP2.3 SheetWorks for Unfold (Embedded) 64bit Patch Version Installation Procedure ***** Improvements ***** [Create Sheet Metal Solid] - afpc5508/afpc5536/afpc5575/afpc5652 Fixed an issue that mistakenly created an unnecessary surface model document if Options > [Unfold Condition] > both [Into New Drawing Document] and [Output Standard 3 View] are selected. - afpc5509 Fixed not to show the warning message [Since the parts are open from the assembly, it will save.]. - afpc5510 Fixed an issue of active document switching process that mistakenly showed the file saving dialog. [Batch Tube/Structural Steel Unfolding Process] - afpc5464 Fixed not to show the warning message [Since the parts are open from the assembly, it will save.]. ***** Installation Precautions **** (1) Close SheetWorks before starting installation. (2) This patch file is effective for the target software and version only. Confirm that the target software and version is installed. (3) The target software is SheetWorks for Unfold (Embedded). (4) This patch is NOT effective for SheetWorks for Unfold (Addin), SheetWorks for Design, and SheetWorks for Tube. (5) The target software version is from [Ver17-SP2.0 (17.2.0.1)] to [Ver17-SP2.2 (17.2.2.1)]. (6) The version number will be [17.2.3.1] after installation. ****** Installation Procedure ************ (1) Close SheetWorks in the installation destination machine. (2) Run [V17SP2.3Patch_Unfold_Embedded_64.exe]. (3) Proceed installation according to the dialog. @* If the [Program Compatibility Assistant] window appears while installing, select either [This program installed correctly] or [Cancel].