SheetWorks for Unfold Ver.17SP2.2 Release Notes 					
											
											
	Following issues are resolved in Ver.17 SP2.2. 						
											
	Error Fixes 									
											
	Define Attribute/Define Attribute(Tube)/Define Structural Steel Attribute 			
	- 	afpc5216 									
		Fixed an issue of configuration switching process that failed to obtain a base front face. 		
											
	Create Unfold Drawing 								
	- 	afpc5048 									
		Fixed an issue that mistakenly separated faces of flat part as a result of error of margin. 		
	- 	afpc5125/afpc5174 								
		Fixed an issue that failed to create a flat part. 					
	- 	afpc5378 									
		Fixed an issue of automatic face splitting determination process that mistakenly separated faces of flat part.

***** Installation Precautions ****

(1) Close SheetWorks before starting installation.

(2) This patch file is effective for the target software and version only.
Confirm that the target software and version is installed.

(3) The target software is SheetWorks for Unfold (Embedded).

(4) This patch is NOT effective for SheetWorks for Unfold (Addin), SheetWorks for Design, and SheetWorks for Tube.

(5) The target software version is from [Ver17-SP2.0 (17.2.0.1)] to [Ver17-SP2.1 (17.2.1.1)].

(6) The version number will be [17.2.2.1] after installation.


****** Installation Procedure ************

(1) Close SheetWorks in the installation destination machine.

(2) Run [V17SP2.2Patch_Unfold_Embedded_64.exe].

(3) Proceed installation according to the dialog.

�@* If the [Program Compatibility Assistant] window appears while installing, select either
[This program installed correctly] or [Cancel].